Eiki LC-X4L Bedienungsanleitung PDF herunterladen (Seite 40)

SETTING

This function turns Projection Lamp off when this projector detects

signal interruption and is not used for a certain period in order to

reduce power consumption and maintain Lamp-life. (This projector is

shipped with this function ON.)

Power Management function operates to turn Projection Lamp off

when input signal is interrupted and any button is not pressed over 5

minutes. This function operates as follows;

1. When any input signal is interrupted, “No signal” and counting

down display appears (for 5 minutes).

2. After counting down for 5 minutes, projector lamp and READY

indicator are turned off.

3. When READY indicator flashing, Projection Lamp can be

turned on again (Power Management mode).

In this Power Management mode, Projection Lamp is

automatically turned on when input signal connected or

projector is operated with any button on Top Control or on

Remote Control Unit again.

Power management

On start

When this function is “On,” projector is automatically turned on just

by switching MAIN ON/OFF SWITCH on.

Note ; Be sure to turn projector off properly (refer to section

“TURNING OFF PROJECTOR” on P21). If projector is turned

off in wrong steps, On Start function does not operate

properly.

Time left until Lamp off.

Move pointer to item and then press

POINT LEFT/RIGHT button(s).

Press SELECT button at this icon to

display other items.

Press SELECT button at this icon to

display previous items.

On start

Remote control

This projector has two different remote control codes; factory-set normal code (Code 1) and secondary code (Code 2). This

switching function prevents remote control operation mixture (jam) when operating several projectors or video equipment

together.

When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”

To change code of Projector;

Set Remote control in SETTING MENU to “Code 2.”

To change code of Remote Control Unit;

Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds.

After changing code, make sure Remote Control operates properly.

To return to normal code (Code 1), operate both projector and Remote Control in ways above again.

NOTE : When batteries of Remote Control Unit are replaced or ALL-OFF switch is turned to “ALL-OFF,” remote transmit

code automatically returns to normal code (Code 1).

This Projector is equipped with 2 Projection Lamps and a number of using lamps can be switched to 2 lamps or 1 lamp.

Using 1 lamp maintain life of Projection Lamps.

To change over Lamp Mode

1. Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT buttons to select SETTING and

press SELECT button. Setting dialog box appears.

2. Press POINT DOWN button to move a red frame pointer to “Lamp mode”. Set "2 lamps mode" or "1 lamp mode" by

pressing POINT LEFT/RIGHT button(s). When Lamp Mode is set from "2 lamps mode" to "1 lamp mode" image

becomes little darker. When Lamp Mode is set from "1 lamp mode" to "2 lamps mode" image become brighter

gradually.

Lamp Mode

NOTE : After changing Lamp Mode, it cannot be switched again for 90 seconds.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Eiki LC-X4L Bedienungsanleitung Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Eiki LC-X4L