Eiki LC-XT1 Bedienerhandbuch Seite 45

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 51
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 44
LC-XT1
.
Follow these steps to replace the lamp assembly.
1
Check the number of lamp to be replaced on Lamp Status
Display.
2
Turn off the projector and disconnect the AC Power Cord. Allow
the projector to cool down for at least 45 minutes.
3
Remove the two screws on the Lamp Cover and press the
button to open the Lamp Cover. (See right figure.)
4
Loosen the two screws and pull out the Lamp Assembly to be
replaced by grasping the handle.
5
Replace the Lamp Assembly with a new one and tighten the two
screws. Make sure the Lamp is set properly
6
Replace the Lamp Cover and tighten the two screws.
7
Connect the AC Power Cord to the projector and turn the
projector on.
8
Reset the Lamp Replacement Monitor Timer. (Refer to the
section “Lamp Replacement Monitor Timer” on page 41.)
NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER
when the lamp is not replaced.
CAUTION : Do not operate the projector while any of lamps is removed.
It may result in malfunctions, fire hazard, or other
accidents.
Seitenansicht 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare

Schwinn Folding Bicycle podręczniki

Instrukcje obsługi i podręczniki użytkownika dla Rowery Schwinn Folding Bicycle.
Dostarczamy 1 pdf podręczników Schwinn Folding Bicycle do pobrania za darmo według typów dokumentów: Instrukcja Właściciela






Więcej produktów i instrukcji dla Rowery Schwinn

Modele Rodzaj dokumentu
Sting-Ray Bicycles Instrukcja Właściciela   Schwinn Sting-Ray Bicycles Owner's Manual, 2 strony
Folding Bikes Instrukcja Właściciela   Schwinn Folding Bikes Owner's Manual, 11 strony
26" Adult Tricycle Instrukcja Użytkownika   Trike Assembly Manual, 16 strony
IC Elite Assembly Instrukcja Użytkownika   Assembly Manual - Schwinn Equipment, 12 strony